The radios that are bought separately from the market alone have these individual fuses. The fuse box may in different locations depending on the making of the automobile. There are two important steps that can be followed to overcome this fault.There are many reasons for the radio to get repaired and stop working suddenly. Different cars have different technologies and designs that are used. But one major reason that many have come across is due to the blown out fuse. The radio is then pulled carefully so that the connections are not disconnected. It is then checked. For this the vehicle is turned off. To check this, the dash board is removed after disconnecting the battery of the car. It does give an idea about the connections and location of fuses. This is one of the easiest instructions on how to change a fuse in a car radio is useful and is understandable by anyone. For doing that these lessons on how to change a fuse in a car radio is useful. This fuse is removed. The new fuse is then replaced in the same position and radio is inserted back Hand Glove Knitting Machine to its position. The fuse is present in the behind of the car stereo. The radio would have worked if the damage was with the fuse in the car. This is removed and checked for damage. The new fuse is pushed back to the original position slowly and has to fit in properly. Another fuse similar to the dimensions of the fuse that was blown is bought from a near by automobile dealer. Once the fuse is located, the fuse is necessarily checked for damage like burnt side. The direction of the fuse must also be ensured to be the same as that of the rest of the fuses. Though it sounds easy it needs skill and knowledge to do this. The fuse may be damaged either in the car that is attached to the radio or the audio system of the car or the fuse that is available individually for the radio. The dash board may be held by additional clips. This can be done by following the image that is provided in the cover of the fuse box. Once the fuse box is found, remove it and find the particular fuse that connects the radio. The dash board is unscrewed and removed to reveal the fuse box. If that is not the case, the fuse in the radio would have got damaged. But these instructions are given as generalized as possible to make sure many number of people can be benefited by it. It may be below the steering wheel, around the glove holder, or below the covering of the car. Fuses are easily available in any shop that deals with hardware. If it is damaged, it replaced by a similar one. It is made easy so that a new user can also use these instructions. After replacing the engine may be turned on and radio is checked. This may be blackened if blown. One is to locate the damaged fuse and the next step is to replace it. The first step is to locate the fuse.